Installation & Care Guide: Protecting Your Vehicle

Welcome to your new custom-fit car cover. To ensure a perfect fit and maximum protection for your vehicle, please review these quick installation and care instructions before your first use.

🛠️ Car Cover Installation

Installing your cover is a quick, straightforward process.

Step 1: Locate the Front. Unfold the cover next to your vehicle. Look for the "FRONT" tag or logo sewn into the inside hem to easily orient the cover.
Step 2: Secure the Mirrors (If Applicable). If your custom cover features mirror pockets, pull the cover over the hood and slide the pockets over your side mirrors first. This acts as an anchor for the rest of the installation.
Step 3: Secure the Front and Rear. Stretch the elastic hem under the front bumper, then walk to the back and pull the cover over the roof, securing it under the rear bumper.
Note: If your vehicle has a fixed antenna, please refer to the Antenna Patch section below before completing the installation.

🔄 Car Cover Removal & Storage

For the best longevity, avoid dragging the cover across the floor.

Step 1: Unhook the elastic hems from beneath both the front and rear bumpers.
Step 2: Fold both sides of the cover up onto the roof of the vehicle, creating a center strip about 2 feet (60 cm) wide.
Step 3: Starting from the front of the vehicle, fold or roll the cover in 3-foot (1 meter) sections towards the back. Store it safely in your provided bag.

⚙️ Accessory Installation Guide

Antenna Patch (For Non-Retractable Antennas)

If your vehicle has a fixed antenna, use our provided patch to create a custom, weather-sealed opening in minutes.

Mark: Pull the cover over your vehicle until it rests against the antenna. Mark the exact point of contact.
Cut: Carefully make a very minimal incision at the marked spot—just large enough for the antenna to pass through.
Seal: Slide the antenna through the cut, then apply the adhesive antenna patch over the hole. Press firmly. The patch will lock the fabric in place and maintain the cover's weather resistance.

Cable Lock System

Secure your cover against theft and strong winds. Our covers feature scratch-resistant grommets at the bottom center of both sides.

Thread the steel cable through the loop at one end to anchor it.
Pass the free end of the cable securely under the vehicle to the opposite side.
Thread it through the remaining grommet and lock it in place using the provided padlock and key.

⚠️ Important Usage Guidelines & Warnings

Failure to adhere to these guidelines may result in damage to your vehicle or the cover. We will not be held liable for damages caused by improper use.

Temperature & Paint Care:

Fresh Paint: Do NOT cover a newly painted vehicle. Consult your painter or body shop for safe curing times before using any cover.
Heat Sources: Do NOT cover a car immediately after driving. Allow the engine, hood, and tailpipes to cool down completely.
Sun Exposure: Ensure the vehicle surface has cooled down from prolonged direct sun exposure before applying the cover.

Moisture & Weather Conditions:

Keep it Dry: Do NOT cover a wet vehicle, and ensure your car is completely dry after waxing before installation.
Freezing Conditions: Rarely, a heavy downpour followed by a sudden freeze can cause the cover to freeze to the vehicle. DO NOT forcefully pull the cover off. Pour warm water over the affected area and gently lift. If you feel resistance, stop and apply more warm water until the ice is fully melted.
Windy Conditions: High winds can get under the cover, causing it to flap or dislodge. Always fasten the provided belly straps/buckles snugly under the vehicle in windy conditions or during long-term storage, even if using the cable lock. Note: A car cover is not a complete substitute for a garage in extreme weather.

General Prep:

Do NOT cover a vehicle with windows, sunroofs, or convertible tops open/down.
Ensure the vehicle is clean; dirt and debris trapped under a cover can scratch the clear coat.